General Wetting and Dispersing Agent Anjeka 6030 Overview

Anjeka 6030 is a polymer dispersant to prevent the aggregation of pigments.

product information

Chemical composition: Multifunctional polymer solution

The data given on this data page are only typical values, not technical indicators of the product.

Active ingredient: 49–51%
solvent: xylene/propylene glycol methyl ether acetate

Density at 20℃: 0.96–1.00g/cm3 

Acid value: 10-15mg KOH/g

Ammonia value: 4–8 mg KOH/g

Flash point: 24℃ 
Color: light yellow liquid 

Storage and transportation

When the temperature is lower than 0°C, delamination or turbidity may occur. Heat to 20°C and mix well.

pay attention

Dispersant The surface treatment of certain organic pigments will have an adverse effect on the effectiveness of the dispersant. In this case, try untreated pigments of the same type.

Application information

Anjeka 6030 has a very high cost performance, a suitable to replace the traditional dispersing wetting agent, can also be used to produce solvent-based low-resin universal pigment paste. Has the following advantages:

Reduce grinding time,
      improve gloss,
      prevent floating and blooming problems,
      improve pigment tinting strength,
application areas

Industrial coatings ●
      Automotive coatings ●
      Architectural coatings ○
      Anti-corrosion coating system ○

Recommended dosage

The amount of additives (purchased form) based on the pigment:

Inorganic pigments: 2%—5%

Organic pigments: 10%-30%

Carbon black: 10%-50%

The above data are empirical dosages, and the optimal dosage of a needs to be determined through a series of experiments.

Joining method and processing guidance

In order to obtain a good performance, it should be added when no pigment is added in the grinding stage. Do not add pigments before the additives are evenly mixed.

package

—25kg inner coated iron drum

—180kg ring plastic drum